Universal-electronics URC-1047 User Manual download pdf (Page 18)

TROUBLESHOOTING (continued)

PROBLEM: No volume on a second TV.

SOLUTION: Follow instructions in Changing Volume Lock

(see page 17).

PROBLEM: CH+ , CH – ,and LAST do not work for your

RCA TV.

SOLUTION: Due to RCA design (1983-1987), only the original

remote control will operate these functions.

PROBLEM: Tried “Search Method”and still could not find a

working code.

SOLUTION: Try the “Search Method”again after clearing out

the device key as follows: Press and hold SETUP

until mode key blinks twice, then release.Next

enter 9 - 9 - 2.Then press and release the mode

key to be cleared twice.

PROBLEM: Remote control does not turn on Sony or Sharp

TV/VCR Combo.

SOLUTION: For power on, these products require program-

ming TV codes on the remote control.For Sony,

use TV code 0000 and VCR code 0032.For Sharp,

use TV code 0093 and VCR code 0048.

INSTRUCTIONS TO THE USER

This equipment has been tested and found to comply

with the limits for a class B digital device, pursuant to part

15 of the FCC Rules.These limits are designed to provide

reasonable protection against harmful interference in a

residential installation.This equipment generates,uses

and can radiate radio frequency energy and if not

installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation.If this equipment does

cause harmful interference to radio or television reception,

which can be determined by turning the equipment off

and on,the user is encouraged to try to correct the inter-

ference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

Time Warner Houston Manual 11/20/02 3:54 PM Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

No comments

Universal-electronics URC-1047 User Manual Page 18